Question about RoadMate 700 GPS Receiver
...board (attached to rear housing). If no change, then try resetting GPS user data. At User Menu (after reboot), press "-" key and repeat key at the same time. select reset GPS user data and cross your ...
...GPS board (the board that's attached to the rear cover) has to be connected as well. If you see any loose cables and you find a place it fits, plug it in. So, the answer to your question is yes, that ...
...GPS Fishfinder? when switched on for use a message on the screen "Low Voltage" appears after about 20-30 mins. If I don't switch it off it will turn off its-self. Thanks Norman The power inverter ...
Garnin 12: Half the function keys no working. Power, quit keys working, page, Mark, enter and go to keys are not working. Receives satellites. It could be that the contact on the board under the ...
...with the logic board. Did the GPS get wet or did it drop, was there anything else the preceded the moment it stopped working? There is a company that sells GPS logic boards for TomToms : GPS ...
board and the GPS receiver IC. When this happens, you won't be able to pick up satellite reception. The main board is trying to upload a fresh copy of the GPS firmware stored on your Nuvi but it fails
Question about 7100 GPS Navigator GPS Receiver
The USB connector inside the Navigon 7100 is The USB connector inside the Navigon 7100 has broken off the board. Do I have to replace the whole board? If so where can I get an inexpensive one? I ...
...board inside the gps.Is this the incar gps? Apparently my Garmin 545 GPS was connected to the power supply without the inline fuse. It was working fine but during a problem with the power while ...
...gps just stopped working no power its not batteries and ideas wont power up at all Open the unit up and remove the mother board. Place the board on a cookie sheet propped/supported by a small wad of ...
Question about Car Charger Vehicle Power Adapter Cord (PNAN0206SWXXX) for Magellan Roadmate 1700 7" GPS Nav...
...board. Gps was working good until plugin was pull out . Hi, yes it's possible you need a soldering iron and 60/40 rosin core solder, remember that soldering iron can make serious burns so be careful, ...
Usually answered in minutes!
1,678 Questions
1,343 Questions
1,187 Questions
1,096 Questions
889 Questions