Questions & Answers for: Chevrolet Traverse gm recall notices

Question about 2009 Traverse

1 Answer

rear wiper is not working. the fuse in the passenger compartment appears to be good. Call your dealear i have heard this complanet about 4 times now see if it is a recall and see if your warrenty will

Ad

Question about 2011 Traverse

2 Answers

...GM will never admit there is a problem. Cheaper to pay off families of people dead or injured than to re-tool the plant and/or do a recall. If you own one of these "gubbment motors" vehicles, get rid ...

Ad

...and at that time the dealer repaired it for free. We were never told of a problem but apparently GM has Technical Service Bulletins about the problem. Because this caused a complete loss of power ...

Question about 2009 Traverse

1 Answer

...change the situation. Voltage was good at the relay terminals and I plugged the relay into another GM car and it worked fine. The NEXT place the voltage goes to is the LOW BEAM HEADLIGHTS. The

...service at 1-800-521-7300, Chevrolet customer service at 1-800-222-1020, GMC customer service at 1-800-462-8782, and Saturn customer service at 1-800-553-6000. GM's number for this recall is

Question about 2009 Traverse

1 Answer

...bolts.the bolts are flex bolts and can be used once.just downloaded the chevy traverse gm manual from ebooks.com for 11.99 for a havac achuator problem .same book the dealer has but in ...

how do I find the firing order for a 3.6l gm lambda engine? I need to replace the bank 2 sensor 1 o2 sensor. Is this in the front or towards the firewall? Firewall Side

was there a recall on the ignition switch on a 2010 chey traverse The only recalls so far are ."..Recall # 104283 ...Seat Belts ..which is important and Recall # 102625 Side window air bags...Both of ...

...traverse? Found this in your owners manual. If you don't have an owners manual, you can go to, my.gm.com, it's there. Fuse Block - I/P= instrument panel Under the lower right side of the instrument ...

...to see how it works. When it fails, it's usually due to a bad purge valve or a plugged vent valve. GM has had lots of problems with ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...