Questions & Answers for: HP OfficeJet glue plastic

it? Hi, This is exactly the problem I have so I guess I need to find the piece of plastic with letters or marks you are talking about and glue it. Where is it located? Thanks Lior what is the porblem?

...plastic and heat the strip with a hairdryer and peel it off. use glass cleaner to remove the glue, and then put the strip back on where it was, but straight. Do not reglue it with new glue, because ...

...plastic piece in the print cartridge holder which holds the spring which supports the black cartridge in place broke off. Is it worth repairing or should I just replace the printer? If the spring did ...

...Plastic Tab" is broken. I used a bit of Crazy Glue to keep the spring in place, but I still am getting the same Error Message: "Remove and check Cartridge on Right" This is a genuine HP #96 Black Ink ...

...PLASTIC BROKE OFF THE INK CARTRIDGE HOLDER AND I KEEP GETTING AN ERROR READING TO REMOVE AND CHECK CARTRIDGE N RIGHT. I TRIED TO GLUE IT, BUT IT DID NOT CORRECT THE PROBLEM. Is the print cartridge ...

...plastic ball that has after filling it you must close it with hot glue but i insist that i can not guarantee for the result Yeah, refilling is not worth it. You're better off with buying a new ...

...plastic latch/cover to the black ink cartridge. In most cases that black tab has broken off, and the cover is not setting the cartridge in the printer properly. Use some super glue/nail glue to glue ...

...plastic or glue something idk.. well anyways, i just wanted to share my store. the clicking on my printer came from the scanner lazer light not being able to reach the right side of the printer box ...

...plastic top plate. With a torx t10 bit you can lift this plate up and clip the sensor back into position. Theres 2 screws on the front and 6 along the back, some are difficult to get to but I just ...