...plastic is it made from? Would an epoxy or super glue fix the broken arms? Thank you.............Bud The disc carrier you're looking for is Part No 7002058 (the number may be stamped somewhere on the ...
plastic expanded and it was very difficult to get the blade or other attachments on and off the spindle.I put some super-glue in the cracks and then put clamps on the spindle to squeeze it back to its
...plastic piece is NOT doing it's job. A possibility that the micro switch inside which is actuated when you put the top on......the one you are tooth picking....has become dislodged, or the grooves ...
housing around blade cracked, need a new one blade is fine, just plastic cracked Sorry but seriously doubt that you can buy a housing alone . try some good glue .
...glue from fingers so ok or not after drying? - Some glues say ingredient may cause cancer. == Given above, need to know which plastic used, which glues work, which work with w/o chemical hazard since ...
...plastic items with either super glue or 2 part epoxy resin. Then for reinforcement at the edges. I take a 2cm (aprox) piece of thin wire. Like a staple. Then heat it with the soldering iron. sliding ...
Question about EP91 Quad-Blade Food Processor
...glue if anything got in there. Does it have a removable spindle (mine has 2 so don't say no such thing. Some are not removable) Is the spindle fully intact? No cracks? They make new products to fail ...
Usually answered in minutes!
89 Questions
72 Questions
69 Questions
104 Questions
47 Questions