Questions & Answers for: Harman Kardon glue plastic

...glue i tried seemed to melt the plastic. use a clear silicone based sealant (similar to the type used for caulking and in fish tanks) I'm guessing you used CA or superglue, and thats what melted your ...

...plastic casing will snap open , or whether it is glued together. Alternatively, if this can't be done, can anyone suggest how I could repair this because the sound is a bit fuzzy at times because of ...

...magnet back in place? right now that top speaker is out of service. I understand that I'lll have to glue them back together which isn't a problem, I just want to get that magnet back in place. Any ...

plastic latches. tks. Joewosh, did you ever get this fixed? I have the same problem now and trying to find a solution. Thx! I was able to open a Soundsticks II satellite by carefully tapping along the

the glue is loose in my soundstick how do I open the soundstick hi have you found any solution about opening the case

...Shop has advised us that electronics are usually not fixed just replaced. Carolyn The sub-ts5 had glue that went conductive on the circuit board and when it is removed unit should work again a good ...

coins and cereal inside the bass enclosure. how to open. Use a razor knife and cut the adhesive along the seam open it up remove coins and cereal use a couple drops of super glue put it back together

...sticks II have come apart at the seams. If I tilt them they stay together from gravity. Is there a glue or tape that I could use to put them back together without affecting their sound quality? Your ...

...of the drivers, and can be carefully placed back in place (you can line them up with the original glue marks). A few drops of super glue will hold them. Now clean up the inside parts and test the ...

...so as not to damage the screw heads as they are tight. On reassembly, you may need to use glue to replace the rubber feet if the mushroom becames damages during