...gfci receptacle. check breaker, may have tripped off. I turned a switch in the back of self defroster receptacle and it turned back on. Just so happen that the light bulb in the freezer burned out at ...
Question about SUD6000HQ Dishwasher
...GFCI the dishwasher's plugged into with a volt meter and got 120V and the interupter is working properly. I open the bottom panel and the junction box and got 120V there. I took the door appart and ...
Question about 5' Jacuzzi Tub Bathtub Cetra 532 H525-969
gfci plug in 15amp the pump starts runs for 1 or two minutes if I hold button down (magic touch switch) will not stay on if I just push button. If I push button half way when it goes off I can push it
...GFCI receptacle with a reset button. If it is, push the reset. If it isn't or if the dishwasher's cord is wired directly to the electrical box, look for any other receptacles in the kitchen that have ...
...GFCI's in the garage had tripped also (fridge is not on GFCIs though). Is there some sort of reset on it that may have tripped? There is cold air blowing out in both sections, but not enough to cool ...
...will not turn on CHECK OUTLET THERE SHOULD BE GFCI AND THE HAVE A RESET BUTTON, MAKE SURE IT HAS POWER. IF IT HAS POWER CHECK THE SWITCH'S DOOR IS WORKING!!! THIS IS ONE OF THE MOST COMMUN
Question about 5' Jacuzzi Tub Bathtub Cetra 532 H525-969
...switch has to be located so it is at least a minimum distance of 3-4 feet from the edge of either a tub or shower stall, and it must be connected to a GFCI protected circuit. Normally any whirlpool ...
...Checked circuit breaker and GFI -all OK. No other electrical problems known. Remove unit and check trip/reset switch on unit. Double check GFCI receptacle with plug tester with GFCI test
switch that is off, (the same electrician who put the GFCI device in a walk-in closet across the hall, also had a switch that turned the whole thing off) or there may be a wiring problem somewhere. at
...GFCI circuit reset switch.Air button activation - check for loose air tube connections or bad air button.Electronic control - contact a spa technician for diagnostics. If the error is not electricity ...
Usually answered in minutes!
79 Questions
19 Questions
13 Questions