...lock out) hub, you are going to be there a while. The center hub needs to come off, and ALL of the internal wheel bearings need to come out. The whole locking hub must be removed in order get the ...
Question about 1995 4Runner
lock hubs? Hello, I just read about the 1995 4Runner rotor / hub answer you gave but your answer dealt w/ only manual lock hubs...I have auto lock. Is it any different? I've the same center 6 nuts off
...to take apart the 4x4 hub to get to the lock nut for the bearings then you have to reome the hub and rotor assy,then you have to press the wheel studs out to remove the rotor,then reverse the
...the wire harness from the clip, unplug. Remove the pivot bolt, plate washer, adjusting lock bolt and generator. Please be sure to rate me if you find this information useful, thanks for using
...lock washer and adjusting nut. Remove thrust washer and outer b earing. Remove axle hub and rotor. Remove grease se al and inner bearing. Press hub bolts out of axle hub. Remove retaining bolts, and ...
after changing the brakes and rotors the front drivers side rotor and tire wobble. it seems the rotor hasnt locked into place. is there a keeper that holds it into place or am i missing another part? ...
How do I service the rear brakes without a negitive side effect screwing up the anti-lock system? I have ability to pull the rotors, have them turned and replace the pads. But I am concerned about an ...
...brackets (when you put the caliper mounting brackets back on lock tite hould be used). and they should be east to hammer off (there may be a little clip on one of the studs holding on the
Question about 2006 Corolla
How much should it cost to replace calipers and pads on a 2005 6cyl 2wd 4 Runner? One is frozen If they order the parts from rockauto its about $630-700 in parts. $50-60 front and rear brake pads, $ ...
Question about 2006 Corolla
I have a Toyota Vitz 2007 KSP90 and I was told that it is dirty that is why my ABS and Handbreak warning lights are on how do i locate it and clean it. If it is the HALL sensor at the wheels, it is ...
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,231 Questions