Questions & Answers for: Jeep generator rotor lock

the rotors are stuck on the hub on the front the brakes were worn down to metal. I can get calipers and shoes off but not the rotors. Is there something holding them on like a clip or somethin g. The ...

Ad

Question about 2005 Grand Cherokee

1 Answer

Feels exactly like warped rotors only its not. I put new lifetime rotors from NAPA on my 2005 Jeep Grand Cherokee because of the pulsing brakes. It didn't fix the problem. Could a caliper be pulsing ...

Ad

Question about 2001 Grand Cherokee

1 Answer

all four brakes lock-up I just put all new brake pads and new front rotors on my 2001 jeep grand cherokee and now after they warm up all four brakes lock up. can you tell me what the problem is? could

Question about 2003 Grand Cherokee

1 Answer

how do you remove the front rotors? is there a retaining screw that I am not seeing On the very center of the wheel: is there a Cotter Pin, Nut Locking Cover, and Large Nut? Remove the Cotter Pin, ...

2003 Jeep Liberty - recently replaced brake pads a... 2003 Jeep Liberty - recently replaced brake pads and rotors and now drivers side rear wheel will intermittently lock up which creates tremendous ...

...rotor cap button, make sure it getting contact, Or could be your ECM.Does your check engine light come on when you turn your key to on postion, Just go have the thing scaned at a shop, should cost ...

Question about 2004 Grand Cherokee

2 Answers

rotors keep warping Could be a number of problems. Here are a few. Defective Brake PadsBrake pads that are defective and/or incorrectly installed can, over time, cause brake rotors to warp and become ...

Question about 2004 Grand Cherokee

1 Answer

My 2001 Jeep Grand Cherokee 4.7 V-8 shakes something awful sometimes when I brake at speeds of 50mph+. It then starts to wobble and doesn`t brake good. What is causing this to happen and how do I fix ...

Question about 2004 - Liberty

1 Answer

jeep liberty front brakes lock on ? front brakes lock on when hot ? new calipers,rotors and pads, bled brakes well and flow was good from both lines, solution lasted 4 days and now front are locked on

lock up.... I've changed the lines, fuid, sensors, pads, moulator what am I missing? Hi On a Kipor KDE 19 STA generator, is there a splined collar connecting the motor to the generator inside the bell

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...