Questions & Answers for: Chevrolet generator locked rotor

Question about 1997 S-10 Pickup

1 Answer

Anti lock brake light on I have a 1997 Chevy S10 pickup with anti lock brakes and I just changed the two front rotors and I made sure that the new rotors were for anti lock brakes, but now my anti ...

Ad

...distributor cap and my rotor is locked down tight what is the best way to remove it without damaging anything?? Gently pry the rotor off by putting screwdiver between the rotor and the pick-up

Ad

plug in or start the gen. First you have to check(visuel & measure) on the excitation system ( thats include the rotor ), when you have problem there, you won't get voltage on the generator(stator

Question about 2004 TrailBlazer

2 Answers

brakes pulsing when applied,now abs light on dash usually when it is pulsating in brake pedal, it is the front rotors that are warped. replace front rotors. the abs light does not have anything to do ...

Question about 1995 Blazer

1 Answer

I HAVE A 95 BLAZER WITH NO SPARK , CHANGED ALL COMPONETS I COULD FIND , STILL NO SPARK , NOW WHAT DO I DO Could be the ignition module. It is located on distributor under rotor . Unscrew distributor ...

Question about 1995 Blazer

1 Answer

...generator can be overhauled. The brushes, diodes, rectifier bridge and voltage regulator all can be replaced along with the stator, rotor and bearings although now days it may be cheaper to replace ...

Question about 1995 Blazer

1 Answer

how to change rotor on rear 2001 monte carlo it has a drum parking brake inside of rotor remove caliper & make sure u wind the parkbrake shoes right back so rotor spins freely then remove any ...

...and fit onto the rotating part of the wheel, outboard by the brakes. These are actually electrical generators which when spinning create a small electrical charge which is picked up by the pick ups ...

Rotors locking up after new brakes, rotors, calipers and brand new hoses rotors only lock up because the brake fluid has no where to return to when it gets hot Problem most likely in the master ...

...rotor. If the generator has field control circuit failure, the generator defaults to an output voltage of 13.8 volts. Body Control Module (BCM) The body control module (BCM) is a GLAN device. It ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...