Questions & Answers for: Briggs & Stratton generator clean power filter

...clean filter will not. It may have oil in the filter too. Bad Gas Mixer....if Two Cycle.....Burning Gas/Oil mix if Four Cycle.....Got The Gas Cans Mixed Up Dude...or Dudess my gnerators burning oil ...

generator doesn't start Hi Check the spark at the plug,compression and carburation.Priming the engine,putb some gas in the cilinder and start the engine.If the engine runs only the gas you puted in ...

...generator won't run for more than 5 seconds. When it shuts down the oil safety light comes on. I made sure there was oil and I'm not on a slant. Still did the same thing. Changed the oil level sensor ...

...filter between tank and carb. you also can clean the carb. and check membranes in dthe carb. also make sure that the oillevel is ok when it is a little low the gen can die on its oilprotection. this ...

...generator that runs on propane, it will not run unless I cover the air intake with my hand. The tank is good, the regulator is good. If I choke the intake down to about a half an inch it runs great ...

generator. I cannot get it started. It has gas and oil but will not start. What could be the problem Ensure choke is turned on while starting. Ensure spark lead is fully pushed onto plug. Remove spark

...generator idle.Now, if this governor system is working. Then look at carburetor. Their is a nut or screw in type solenoid that holds the fuel bowl on. Remove this solenoid/bolt and clean out the ...

...generator. I accidentally spilled some oil on it during a hurricane and cleaned it. However, when I try to start it, it will go on for about 15 seconds and then shut down. sounds more like a fuel ...

filter air cleaner is clean carby has been cleaned but the engine will only run on half choke air cleaner on or off .is there a mixture screw it,s not getting enough gas, your carburater needs cleaned

...generator will not stay running check fuel filter . check oil level. check oil level sensor circuit for broken /loose wire. check for vent blockage in filler cap. clean air filter and make sure that ...