Questions & Answers for: Northstar generator brushes

Ad

Question about Generator 9 Hp, 5500 Watt, Gasoline

2 Answers

...brushes? The generator has less than 50 hours on it. thanks! Keith Small generators like this almost always have 2 stator windings 180 degrees out pf phase, that's how it makes the 220. At the back ...

Ad

Question about Generator 9 Hp, 5500 Watt, Gasoline

1 Answer

motor runs but does not put out power reset buttons ok check brushes..then check wireing...if nothing is wrong with them...check AVR card if u have any further questions email me at ...

Ad

Question about Generator 9 Hp, 5500 Watt, Gasoline

1 Answer

...generator. model BS1550 w Runs good but no power to plugs. circuit breakers are not poping out could they be bad. Breakers could be bad, but no power to all the plugs, including the 240vac plug ...

Question about Generator 20 Hp, 13,000 Watt, Gasoline

1 Answer

...Generator runs great, but not putting out voltage. If you have checked the stator, rotor and brushes and they appear alright then it is probably a voltage regulator. The honda dealer can run a test ...

Question about Generator 18 Hp, 10,000 Watt, Gasoline

2 Answers

...brushes are worn out, no excitation field is supplied and no output is generated. Replace carbon brush if found worn-out. Use an analog multitester to check the continuity of the carbon brush and the ...

Question about Generator 9 Hp, 5500 Watt, Gasoline

1 Answer

generator runs but does not put out power reset is not out no power to any plugs, checked it with my wiggy check AVR card...most of the times it is the prob. if it works...then chek brushes.. then ...

Question about Generator 13 Hp, 8000 Watt, Trifuel

1 Answer

I have a northstar 13hp 8000ppg generator. I was using it last wk and it was working fine. when it quit. I have checked the curcuit breakers and they are all ok. I have tested the generator and there ...

Question about Generator 9 Hp, 5500 Watt, Gasoline

1 Answer

...generator (does not move,). The stator will have several pairs of leads connected to the control panel.  The rotor also has winding however is the center revolving shaft. The rotor creates  ...

...voltage. You can do this by adjusting the screw at the top of the carb. Do so slowly and use the voltmeter to check the output. How to test your Electricity Generator AVR Brushes and Alternator

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Northstar Electrical Supply Experts

John Trevino

Level 3 Expert

1407 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

mikenearman

Level 2 Expert

127 Answers

Are you a Northstar Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...