...generator drive belt. This is especially important on the longer, multiribbed V-belts. Pry the idler or generator pulley to adjust the belt to specifications. Tighten the idler or generator pulley ...
Generator Drive Belt 11 6312 Crankshaft Pulley 12 ? Water Pump and Power Steering Pump Drive Belt Adjustment Bolt (Part of 8678) 13 8678 Water Pump and Power Steering Pump Drive Belt Idler Pulley 14 ?
...generator lead, the tool will become hot enough to cause a serious burn. 1. Disconnect the negative (-) battery cable. 2. Loosen the belt tension by turning the drive belt tensioner clockwise. 3. ...
...belt over generator pulley (10344). 4. Adjust the drive belt tensioner as outlined in Section 03-05. 5. Install wiring terminal and attaching nut on generator output terminal. 6. Install wiring ...
...belt. Remove generator pivot and mounting bolts/nut. The diesel engine uses a bolt at top mounting and a bolt/nut at lower mounting. Position generator for access to wire connectors. Remove nuts from ...
generator belt. 4. Install the new generator belt and adjust it to specification. 5. Tighten all bolts to the specified torque. Tightening torque: Mounting bolt: 2 7-38 ft-lb (37-52 Nm) Adjusting bolt
...belt. Remove the generator lower mounting bolt. Lower the vehicle. Disconnect the wiring from the generator. Disconnect the electrical connector from the A/C pressure switch and clutch coil. Remove ...
...belt The generator electrical connector The generator B+ lead The generator B+ terminal nut Torque to: 115 inch lbs. (3 Nm) Position the engine rearward. Install or connect the following: The engine ...
Question about 1964 E-TYPE alternator belt, fan belt, belt
generator belt fan with jockey pulley? How can I move the pulley to change the belt without slackening the generator on this Series 1? Thanks. Patrice Probably you cannot. From memory you will have to
Question about 1964 E-TYPE alternator belt, fan belt, belt
...belt from the generator. Refer to Drive Belt Replacement in Engine Mechanical - 3.4L. Click to Enlarge Remove the generator front bolt. Click to Enlarge Remove the generator rear bolts. Click to ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions