Questions & Answers for: Nissan Murano gear problems

Question about 2005 Murano

1 Answer

...be display p and N position in panel and in manual driving mode can not go faster with number 3 of gear how i can arrenge thi problem, disconnect battery 1 ...

Ad

Question about 2003 Murano

2 Answers

Nissan Serena 2000 with hidraulic gearbox , automatic with 220.000 km.Gear box SR20 and gasoline motor.We did put a wrong oil , not NS-1. It was a problem because i cant use the car . Now I buy a oil ...

Ad

Question about 2005 Murano

1 Answer

...ever since I just newly bought it. When it was 5 days old, I had trans problem where you put it in gear it doesn't move. Took to the deasler 5 times never fixed the problem. Until it just ...

Key wont come out of the ignition. Will not allow me to get it out of gear. Car behaves like the battery is dead. I had this problem before when I tried to start it with the wrong key (it has some ...

...gear. For the Igniter burning out, check your ground connection with the motor, make sure there's a good clean ground connection between the engine and the chassis and battery, this can cause similar ...

Question about 2009 Murano

1 Answer

I have a 2009 Murano LE loaded; the tilt steering column makes a grinding noise like it wants to move in the pre-set position but all it does is stay at the lowest setting. What could be the problem? ...

When I put my Nissan Murano into drive it does just that drive but when I want to change into tiptronic you can not use the gears as it just stays in drive.do you have any ideas of the problem You ...

Nissan, Murano, 2000; I have a problem in the first gear. What could it be? the first gear doesn't work but the other gears work just fine. fist gears work , but if you cannot get it into first gear ...

I have a Nissan Murano the gear shudder when I engage the gear when moving forward it goes away after it reaches 60km.What can the problem be? If this is a manual transmission then you need to have ...

...a torn or broken belt spinning and the vehicle won't accelerate properly until I'm past 1st/2nd gear You need to have the engine control computer scanned for fault codes as a first step towards ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...