Questions & Answers for: Nissan Hardbody gear problems

1990 nissan hardbody only shifts into 4th and rev gear no other gears, the shift lever moves to the other gears but but truck will not move Injt: From your description, it sounds serious. If you are ...

Ad

Question about 1989 Hardbody King

2 Answers

...went all the way to the floor without any response and I was obviously unable to shift into any gear. I was told by a friend that sometimes "pumping" the clutch worked. So I tried that and it ...

Ad

Question about 1989 Hardbody King

1 Answer

need to replace my clutch?? because the 1 & 2nd gear are not responding well?? then the clutch isnt the problem. the problem lies within the tranny, it has internal damage affecting 1st and ad 2nd

Question about 1989 Hardbody King

1 Answer

...of the transmission. what else do i have to do to get it apart. my problem is it is stuck in fourth gear.i think a bearing is broke inside. double check to make sure all the bolts are out. ive had it ...

...and can figure out the problem Not sure for exactly your car but most cars have the switch on the gear box witch indicates that you have select the reverse and than it switces on the rear lights. ...

Question about 1989 Hardbody King

1 Answer

...the pully for tdc? can u help? Hi , If you installed the chain correctly making sure that chain and gear marks lign up it should be fine. When you have engine running. check with timing light. Good ...

...a little oil leakage,I check the oil abd powersteering oil no problem.The other thing is in 1st gear I get 20km/h in 2nd about 40km/h in 3rd gear about 60km/h and in mountain passes my 4th gear ...

Question about 1989 Hardbody King

1 Answer

...until it starts idling normal without dying. sometimes when im driving and im coming out of first gear it sputters until I rev it up higher then it goes back to normal. any ideas of what might be ...

Question about 1989 Hardbody King

1 Answer

acceleration problems Nissan Hardbody 3.0 16v TDI 2006 model starts to **** above 2700 rpm in all gears, replaced all the diesel filters , checked for cracked pipes , started to use 10ppm 3 months ago

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...