Questions & Answers for: Pontiac gear problems

...ten seconds.they go up and down ok they are just noisy. It sounds like you have a headlight motor gear problem. Most likely the nylon gear is stripped. Since only 1/2 of the gear is used it will ...

97 5 speed manual sunfire gear issue It felt like my car slipped outta 2nd gear then I had no gears. Yet it is stuck in a gear because I started my car up and had to keep my foot on the clutch. My car

...using key fob. firebird headlamps are a pain, i had a similar problem with mine, the problem is the gears in the motor assembly are made of a soft material-i think plastic actually and the gears wear ...

wont go into overdrive> and wont take off in the right gear You have to scan it. The transmission is shifted by the computer and if it detects a problem, it defaults to 2nd gear and will not shift.

...side light makes grinding noise for about 10 seconds. This problem is caused by the headlight gear being stripped. If you go on ebay, there is someone who sells brass headlight gears. Once you ...

gear box problems.The transmission gear box have be taken aparts and parts have to rebuild it and changes shafting shifting gear rods and parts of transmission gear box.This car have be

...problems of gear ****. GEAR SHIFT ISSUES Transmission in reverse, acts like it's in neutral? http://schematicsdiagram.blogspot.in/2012/04/transmission-in-reverse-acts-like-its.html ============ ...

while drivingtransmission shifts thru all gears but 3rd, doesn't slip just wont go into third gear could problem be solved by fluid and filter change or any other ideas fluid and filter would affect ...

...gear at cruising speed, have to downshift and go through gears to obtain higher speed 4th and 5th gears are for use over 45 and 55mph respectively as they are both Overdrive Gears. If you are above ...

2002 pontiac grand am had 1st and 2cnd gear slippage.i replaced the filter and fluid but now i do not have 3rd and fourth gear it will just not change to the gear i havbe 1st abd 2cnd just fine now ...