Questions & Answers for: Oldsmobile gear knob

Wiper moter comes on, but wipers do not engage,, just started after being frozen down. remove the blades - and see if the little geared knobs turn ? lift the hood - look close to the fire wall where ...

Ad

...gear shift knob off? How do you get the gear shift knob off? 1989 olds delta 88 Royle there is a Cclip type snap ring almost at the base of the handle remove it them pull the knob up watch for the ...

Ad

...gear then pull the handle off of the shifter. Remove anything in your cup holder and then you can snap off the shift console cover and get to the shift linkage beneath it. Spray lithium or silicone ...

Question about 2001 Alero

1 Answer

...gear...look on the back side of the knob...you should see a u-shaped clip head...pry gently under the u-shape with a scredriver to begin removal...then use needle nose pliers to completely pull the ...

Question about 2001 Aurora

1 Answer

...gear...this should best expose the rear of the knob...you should see a u clip that needs to be removed...(needle nose pliers) in order to lift the knob off...to reinstall just put the knob back in ...

...gear shift knob had slipped and was not down far enough on the shaft to engage the release mechanism. Check Park Safety Switch.  This switch can be built into the brake switch or it may be ...

...gear select trim piece from the center console, using a small standard screwdriver to pry the trim piece from the center console. Lift it over the shift knob and rotate it to clear the knob. Remove ...

Question about 2001 Alero

3 Answers

...gear...look on the back side of the knob...you should see a u-shaped clip head...pry gently under the u-shape with a scredriver to begin removal...then use needle nose pliers to completely pull the ...

...gear shift knob on an Alero There should be a small clip you have to pry out below the handle to remove if you look at the backor sides of the shift , you will notice a small staple size clip. this ...

...and when I had to use a screwdriver for a couple days the plastic part that you push in to select gears split and is all out of place If the plastic plunger inside the stalk split, you will need to ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...