Question about Carousel 4400 Slide Projector
shaft the focus knob turns). The gear has either cracked and fallen off or is cracked and slipping on the shaft. Either way, the focus shaft needs to be replaced by a factory-trained repair technician
...knob) has cracked and no longer interfaces with the gear on the slide of the projection lens. The focus shaft can be replaced, but needs the attention of a factory-trained technician. Look for an ...
...knob toward the outside of the projector (to make sure the gear is disengaged) and pull on the lens. If you are careful, you will be able to remove the lens without damaging either the lens or the ...
...gear (inside the projector) on the focus knob shaft. If the lens does not have this "rack", then you should try to find a lens that does. (One source for lenses is www.VineValleyImaging.com). ...
...gear vendor) that is pressed on the focus shaft. Check to make sure the focus knob is secure on the focus shaft (when you turn the knob, the shaft should turn, too). Finally, remove the projection ...
Usually answered in minutes!
1,024 Questions
996 Questions
1,049 Questions
812 Questions
732 Questions