Question about GLTF2940ES Front Load Washer
gear or something inside and replaced it. $150.00 plus later and wah-lah, same thing.I have tried turning off the EXTRA RINSE switch,using only cold water wash/rinse,unpluging the power supply and all
...knob roates from start position but hangs up at about 1/4 revolution and "Heating Delay" lights up. Timer has small gear pull panel off and see if gears are stripped in one spot meaning no teeth on ...
Question about FRS26R4A Side by Side Refrigerator
...gear components exposed, just behind the face plate. Modular units have holes in the module's face plate for test probes. If you see several holes, each marked with a letter, it is a modular unit. ...
Question about FRS26R4A Side by Side Refrigerator
...your problem, I hope this helps you out. yes you have a defective motor in your control knob or bad gears. I tried to help you. Please help me and Rate/Vote on my response. We take the time to answer ...
Question about Dishwasher Timer Assembly - 154295701
...that I can troubleshoot to determine the exact cause ? YOU HAVE SOME FLT THEETH ON ONE OF THE GEARS. pROBABLY CHEAPER AND EASYER TO REPLACE THE WHOLE
...knob is set in the middle on the vent stack as this will cause problems if set to "colder". I have only seen one defective defrost timer (incorrectly assembled) which caused the gear to stick in one ...
Question about Dishwasher Timer Assembly - 154295701
...sanity. Thank you! It definately sounds as though the motor in the timer assembly is dying, or the gears in the assembly are wearing down to the point that the gears can't turn the way ...
Question about Dishwasher Timer Assembly - 154295701
...gear knob. What you were doing is aborting the defrost cycle and allowing frost or ice to build up on the freezer coils. It built up enough to clog the airflow and the temperature in the freezer ...
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
650 Questions
256 Questions