Questions & Answers for: Chevrolet Uplander gate motors

Squeaking near belt area There is constant squeaking near the belt pulley area have you tryed replacing the belt when and if you replace the belt check the pulleys that are driven by that belt for ...

...rear wiper motor? You have to remove the large plastic trim panel at the inside of the rear door/gate to get at the motor. The panel is held on with a series of push-in clips and there could be a ...

...bolt that fits your lug nut tool and the other end is a flat tip screwdriver. With the rear left gate open, you can look along the top of your bumper surface just under the rubber seal and to left ...

chevy uplander rear liftgate will not unlock The tailgate on my 2008 Chevy Uplander refused to open. The unlock fuse was fine. The handle pull worked fine. I could even hear the little motor that ...

...FIRST TURN OFF RADIO THEN DISCONNECT NEGATIVE BATTERY. MARK POSITIONS OF WIPER ARM ON THE LIFT GATE GLASS,THEN REMOVE WIPER ARM COVER AND NUT AT THE PUTSIDE OF THE LIFT GATE, THEN THE BEZEL,

liftgate on 2005 uplander won't open I shut the liftgate yesterday morning after putting a suitcase in the back. Two hours later, when I reached my destination, it would not unlock or lift, and I ...

...switch does not open its lock and the side doors need to be unlocked manually. Cant access the tail gate. any body actually experienced this and found a solution? I've heard need to replace the door ...

Rear lift gate lock stuck in the closed position The rear lift gate latch is stuck in the locked position when the the door is open.......how do you manually release? use a round bar under the lock ...

rear latch lock stuck in the open position Rear lift gate lock/latch stuck in the closed position while the door is open.......how do i manually release or open the latch? use a round bar ( a screw ...

removing rear bumper cover for 2007 uplander removing rear bumper cover Lift the tail gate. There are clips or screws along the top edge. Remove this. The clips all you do is pull the center pin with ...