Questions & Answers for: gate latch

...the latch assembly to release this lift gate. Any kind of major or minor shifting of the lift gate lock latch assembly can cause misalignment that will jam this delicate precise locking

Ad

Question about 2004 Avalanche

1 Answer

...latch. How can I get the tail gate open? How do I replace or reattach the rod to the latch? Hi;The latch/ouside handle is held on by four bolts on the inside of tailgat. Remove the four bolts and the ...

Ad

Question about 2002 Grand Cherokee

1 Answer

The

...overhead message panel. The actually lift gate is closed securely. The lift gate latch is at fault the switch contacts in the latch are worn out replace the liftgate latch and your problem is ...

...gate latch assembly. To get it tested and confirmed there is a troubleshoot guide provided by the service center. To perform this troubleshooting guide you will require a scan tool to diagnose the ...

Question about 1998 Silhouette

1 Answer

...jammed before you do a full replacement. If the latch is closed use a screw driver to open the latch while using the key to open the gate. Once you get the latch open try closing and locking the

...then remove tailgate access cover either handle broken or look inside tail gate for latch rods that the handle moves latch rod either damaged or look for loose or missing latch rods

Question about 2007 Nitro SLT

1 Answer

gate latch, the switch that turns the light on in the dash is part of the latch, also check the wiring inside the rubber tube at the top of the lift gate door when it's open, could be a broken wire in

2008 dodge caravan, rear lift gate will not latch Will go up-down but will not latch How to Replace Lift Gate Latch How to Remove Your Lift Gate Latch

...latch hook. Open the Gate and lose two bolt holding the hook on bottom. Using screwdriver lift the hook just a bit and tight. Close the gate slowly and look if the hook is on center of the ...

...latch the gate. Disabling the delay could cause the gate to not close properly, which could be a safety hazard and may also damage the gate and the gate opener. If the magnet is not grabbing the gate ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...