...gas, so to speak. We had the slow issue and it was the foot pedal. But, rather than replace the pedal I disassembled it, cleaned it, then found a little adjustable pot (resistor). I used a tiny ...
Question about 6038 Mechanical Sewing Machine
...pedal suddenly stops working. If you put in a different pedal, the machine works. Is the pedal defective or is it a machine issue? You diagnosed it yourself! If it works with a new 180 pedal than it ...
My Janome DC2010 sews after the foot pedal is released, begins sewing by it's self, will stop only if the power is turned off Mine just did that. After speaking to the tech where I bought my machine, ...
Question about 6038 Mechanical Sewing Machine
...gas pedal'. You could maybe get an electrian to test the connection under the foot pedal and if the wire is damaged? or maybe the part that plugs in the machine is cracked or damaged?Good luck! ...
Question about 6038 Mechanical Sewing Machine
stopped. When you depress the pedal the motor idles but the needle doesn't go up and down It was working fine. Then stopped. When you depress the pedal the motor idles but the needle doesn'
Question about 6038 Mechanical Sewing Machine
...stopped working, pedal works on sewing machine so that Is ok. Light comes on so there's power Stopped working , pedal works on sewing machine so that is ok, light comes on so there I power - help ...
...stopped working, so believe it is the pedal. When I first put the machine on today to sew, there was no action and pedal seemed off, so thought it was a connection. When i restated machine it sewed, ...
...pedal stopped working. I put another pedal on and it worked for a few minutes, then it stopped working. Is it the pedal or the machine? why would it quit working? it would be a good idea to have the ...
Question about Tiptronic 2040
Brand new Bernina 880. BSR works just fine with the foot pedal but not with the start/stop button. When I push the start/stop button the presser foot lowers but the red light does not come on. Hi, You
Question about Tiptronic 2040
My Memory Craft 8000wil not adjust the speed. It works for 8 seconds and then just stops. It only goes faster on the high speed setting and then just stops. It will only go two speeds slow and fast. I
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions