Questions & Answers for: gas line Water Heaters

...gas line to small? 3/8 copper line. Thanks If you are using a 3/8" copper line for your gas, get it replaced ASAP. It will fail. 1/2" Black Iron is required with natural gas. 50 gallons is a lot of ...

gas line. In the instructions it says a 3/4 inch line, we can find a line with a 3/4 connector but the line is smaller. Is there a line that is 3/4 inch or is it talking about the connector ends? They

Our gas was shut off and when it was shut back on the tankless water heater not working. I can hear the pilot clicking but no flame. Hello, Since it was turned off, there is probably some air in the ...

...gas line to burner,line to pilot light, and thermocouple from gas valve. Remove pipe fitting from gas valve and use large pipe wrench to loosen gas valve. Before you loosen gas valve you will need to ...

...gas line, meter, and regulator are sized properly. Ensure appliance is properly grounded. Check gas solenoid valves for open or short circuits. Ensure igniter is operational. Check igniter wiring ...

...gas line, checking gas pressure, and making sure gas shut-off handle is turned-on and parallel with gas line: Many things cause pilot light to go out including dirty parts, air in gas line, and ...

...line burst. I figured the gas valve was faulty and didn't shut down the burner after demand, since it looks completely oxidized. Am I right on this, or could it be another problem? Also, as a ...

...gas line should have a 3" sediment and drip leg that creates low spot in gas line. Remove cap off end of drip leg and clean out.Have plumber bleed gas line, and check

...error code 11: problem with gas. Do not use flex line, bleed air from gas line, check gas pressure, incomplete combustion, etc. ...

...gas line, undersized gas line to unit (requires 1" gas line to within 10 feet and then 3/4"), wrong type of gas line (cannot use flexible gas line), improper vent (for example too long horizontal run ...