Questions & Answers for: Bosch gas line

...gas line to small? 3/8 copper line. Thanks If you are using a 3/8" copper line for your gas, get it replaced ASAP. It will fail. 1/2" Black Iron is required with natural gas. 50 gallons is a lot of ...

...only ones that can be adjusted are from back in the 60's where they had a seperate gas line off the primary gas line,, you might have to much gas pressure and might have to have a regulator ...

...and nothing ignites, but I smell the gas coming out - Anyone know what to do? how u clean it,u think you never damage the gas line? call the person how to resolve the gas leak if we have. ...

...gas line. My new Bosch 2700ES -NG says it requires no less than 3/4" inside diameter gas line. Do I have to replace all the gas supply lines fromwhre they enter house to the heater? What alternatives ...

Our gas was shut off and when it was shut back on the tankless water heater not working. I can hear the pilot clicking but no flame. Hello, Since it was turned off, there is probably some air in the ...

...gas line), gas line should be 3/4", venting could be issue, or failed sensor, or gas control, or circuit board. Below are Bosch resources. Bosch website is model for helpfulness and easy navigation. ...

...gas line or dirty combustion parts. Typical gas water heaters today suggest cleaning burner parts yearly, including bleeding air out of gas line. Use a burner brush to clean tubes: ...

...line burst. I figured the gas valve was faulty and didn't shut down the burner after demand, since it looks completely oxidized. Am I right on this, or could it be another problem? Also, as a ...

...gas line should have a 3" sediment and drip leg that creates low spot in gas line. Remove cap off end of drip leg and clean out.Have plumber bleed gas line, and check

GAS ON TO PURGE THE AIR FROM THE LINE. dO THIS UNTIL YOU GET A STRONG SMELL OF GAS. aLSO, WHEN YOUR UNIT TRIES TO LIGHT, BUT THERE IS NO GAS, IT WILL TRY TO LIGHT THREE TIMES. aFTER THE THIRD ATTEMPT,