Questions & Answers for: gas gauge Measuring Tools & Sensors

Gas gauge is not working sounds like you have a grounding problem... the gas gauge works off of resistince....if you ground the gas sender wires you should see the gas gauge drop.. if not check to see

...BUT BUT ONLY HALF TANK OF GAS BROKE DOWN GAUGE SHOWING HALF TANK OF GAS BUT NOTHING IN THE TANK PUT GAS IN IT GAUGE WENT UP TO FULL either fuel gauge on dash is bad or the sending unit in tank is ...

gas gauge my gas gauge on my 2002 pontiac montana does whatever it wants.do you think it's the sending unit or another wiring issue? Remove the dash and remove the gas gauge pod - look for burnt ...

...gas gauge stays full. Wont take gas and the gas gauge stays full? This question really doesn't make sense. But if you cant put anymore gas in the car and the gauge says full then you have a full tank ...

...gas gauge sending unit (senses the level of the fuel in the gas tank), the gas gauge sending unit is located inside the gas tank, the gas tank must be removed to replace the gas gauge sending

...gas gauge does not work properly. i filled the tank and the gas gauge reads full. and it works properly past half. then it starts flucturating. i disconnected the gas gauge wires on top the gas tank ...

...gas gauge problem There are a few things that would cause the gas gauge to act up, the gauge itself may be a problemm or the wiring from the dash to the gauge and last the sending unit.   ...

Gas Gauge Not Working I just purchased a 1970 Ford F100 and thought it was low on gas, but when I went and filled it up, the needle on the gas gauge stayed on empty. I have since ran it low on gas and

gas gauge, if the rest of dash and gauges work (the temperature gauge), not a fuse problem. Take off the electrical connector at the gas tank, find the wire for the fuel sender unit in the tank to the

...gas gauge won't work Cathy, 1996 Mercury cougar gas gauge not working. Simplest thing to check first is your fuel gage fuse, make sure all fuses are good. The ground wire could be corroded/damaged, ...