...screw. If nothing comes out, nothing is going in ! In other words the needle and seat are stuck closed. Again, if tapping the carb doesn't start the gas flow, take the carb apart to find out
...gas to carb it starts but as soon as there is no more gas in carb it dies. Is there some kind of diagram that could help me check the carb? follow the fuel line down to the carb. There should be a ...
Question about 2000 VR 2000 Supermoto
...gas into carb throat cause temp start. ?? ignition fine, compression fine, new keyed flywheel. valves tight. past history showed gas belch through carb throat and post burn flume through muffler when ...
Question about ACDelco 3,500 Watt 6.5 HP OHV Portable Generator, CARB Approved #AC-G0002
...sparkplug is firing but not getting gas to the carb.All gas lines are clean and flowing.Gas flows to carb but does not enter carb. maybe vent in carb. is plugged,[not letting air out to let gas
Question about ACDelco 3,500 Watt 6.5 HP OHV Portable Generator, CARB Approved #AC-G0002
gas into the carb. The bolt is usually hollow and has two extremely small holes that allow gas to be taken up to the carb venturi. They are usually clogged and therefore no fresh gas gets through into
Question about ACDelco 3,500 Watt 6.5 HP OHV Portable Generator, CARB Approved #AC-G0002
...gas to the carb. Remove all of the gas. Put a little fresh gas and carb cleaner (about 50/50) in the tank. Try to get that to run (spray more carb cleaner or instant start into the carb to help it ...
Question about Troy Bilt Bronco CRT Garden Tiller
...gas going into the carb is the needle valve and seat in the bowl of the carb. Doing the same thing with 2 different carbs sounds like trash in the gas tank flowed into the carb and is holding the ...
carb. Does gas flow to carb. Observe float, float down gas flows, float up no gas flow. If float is bad replace float assembly or carb. Remove float mounting pin and needle metering valve. Use a bread
Question about 20 HP Lawn Tractor 2690578
...gas into the carb bowl? Could be a plug in the gas line or the inlet in the gas tank which usually has a screen on it is filthy and needs to be cleaned. I'd throw in a clear inline gas filter so you ...
Question about Trailblazer 302 Welder Generator 907217 907216
...gas in carb FUEL PUMP ? FUEL FILTER, GAS CAP NOT VENTING, ENURCHIA VALVE. Pull the gas line off the carb and into a container then turn it over to make sure gas is actually getting to the carb ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions