Questions & Answers for: Polaris Sportsman 500 HO gap iridium spark plugs

Willn't stay running Have replaced carb,fuel pump and fuel lines, it will run for a few mins.and die. i can let it set for a few mins and it starts right up. it acts like its running out of ...

fan will not come on. i changed the fan plug sensor and still will not work put 12v to the fan to see if it works at all

...when it gets hot again it does the same thing. sounds like the coil is weak or the electronic spark box is goin fuel filter been changed ?right gap on the Plugs? need more imfo on it to do more ...

2010 sportsman 500 hd runs then dies turns over won't start dies after running for 20 minuets won't start My opinion, it's running rich and letting it idle for 5 minutes doesn't help. Whether it's ...

starts with prime or starting fluid wont stay running good gas flow to injector gas and spark o k You need to put a gauge on your fuel pump to test your fuel psi just because you have gas to your ...

plugs and these seem to work the best. (Having a spark with a higher heat range will cause the overheat condition). The other thing is your mixture... you may be running a tad rich.. lean it up 1/8 of

while riding my oil filter came loose and i lost about half my oil. The bike stopped running but would turn over just fine. I put oil back in it after tighten up my filter but it still wont start, I ...

...working properly. Replace spark plugs - test run If there is a manual hi speed adjust screw on the carb, have you tried adjusting it at high RPM? reply as a comment to this post and I'll try to

...IRIDIUM BKR6EIX(STOCK#6418).Gap setting is .028. That plug is used on all 500 HO from 2000-2011 Sportsman Models. ...

spark plug gap for a Polaris sportsman 500 year 2010 .070 or 70 thousands of an inch. Please leave feedback. TYVM