Questions & Answers for: galant crank sensor

cant find the crank sensor i can not find the crank sensore on a 2001 mitsubishi galant HI' to find the crank sensor you need to remove timing cove, Is by the crankshaft pulley

...crank position sensor on my mitsubishi galant. You did not specify year or engine size, but... The crank position sensor is located inside the timing cover, behind the crank pulley. The wiring for it ...

...Galant 2.4L engine, the vehicle was retimed but the car will not start. There is not fire from the coils to the crank sensor. The crank sensor was changed to no avail. The fuel pump is not turning on ...

...galant cranked and started. I drove it 15 feet and it suddenly shut off. Distributerm spark plugs and wiring, along with and new ECU has been replaced. Sometimes it gets a good spark. A few times it ...

galant with a 3.0 check engine light came on computer says the crank shaft sensor fault and no activity and it came up with camshaft sensor i put new sensors in it and still didnt change anything I am

...Galant crank and run for about fifthteen minute and shuts off then you have to waita a Hour befor it will start again I change Fuel pump crank sensor and cam sensor when it shut off fuel pump will no ...

...Mitsubishi Galant behind the harmonic balancer or drive belt pully

look for wires and a plastic insulated pick up Do I need to remove harmonic balancer on 08 galant 2.4 to replace crank ...

...crank position sensor on a 1997 mitsubishi galant Follow the link for instructions, and yes 2003 is the same. Go to this site. ...

...Galant 4 cylinder Hello, crank position sensor located at the 2 o`clock position hidden behind timing cover and crank shaft pulley. If you look closely in well lit area or use a flashlight you can ...

...Galant no start p0335 p0340 ... Next I scanned for codes and had crank cam sensor codes. I check .... 3 ... This video may help ... the sensor is underneath the timing belt cover so it is a bit ...