Questions & Answers for: which fuse for the reverse lights

could have gone on the rear dipped light? There is a fuse for the reverse lights. If you find that the fuse is good, have the reverse light switch checked, it's usually on the side of the transmission

...dont turn on when in reverse. I checked all fuses and bulbs and they are o.k. What else could it be. replace the reverse light swith on the transmission Switch lights ok fuse good maybe

...fuse. There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block. ...

...reverse lights don't work when it's put in gear The fuse holder contains 10A fuse F27 which supplies power to the reversing light switch. When you shift into reverse with the engine ...

fuse if both or the reverse switch indicator... Good Luck The reverse lamp circuit will be separate from your other lights. Usually, it is not a separate fuse, but may be ran off the ignition fuse. If

fuse for the reverse lights It is fuse numbre 12 and its located in the insider fuse compartment, under the steering column on the driver's side - 4th column from the left, 4th fuse down. The fuse for

fuse good. reverse Switch? Hi, the reverse light doesn't work on Escape 2010 XLT Automatic trans. I changed the fuse under the hood, and checked every fuse 1 by 1. Under the hood box and passenger

...it be a fuse folt?? where could I find it? check light bulbs are ok in reverse lights. Check wiring to reverse lights - see if they put a fuse at or near where they tapped power off reverse

...reverse number 10 Fuse blows when vehicle is put in reverse. and signal lights are stop working. what ca cause this issue? Possibly an internal failure of the reverse switch. The blown fuse is for ...

...reverse fuse on a 1999 gmc sierra Reverse fuse ???? For transmission reverse or reverse (back-up light's ) hi floyd. not sure if this link will help you out but have a look. Were is the reverse fuse ...