Question about 1981 CX 500 A
...fuel tap to reserve and get yourself to the petrol station to fill up, making sure you then turn your tap to on again. If you keep running out on the reserve it can cause debris in your tank to clog ...
...reserve as the fuel in your tank normally has sediment at the bottom and blocks your filters. This sediment comes from the tank rusting and from the fuel pumps drawing bits from the concrete fuel ...
...fuel **** to reserve and this will allow the reserve tank to empty. Not all the fuel is going to come out unless you blow air into the fuel tank filler, this will then get a large percentage of the ...
...fuel from the reserve position to leak into the on position hole , or you had the lever in the wrong position. If you had the petcock turned to the correct positions, the you may want to drain the ...
Question about 1994 CBR 900 RR Fireblade
reserve? my fuel tap is long at one end and short at the other but which end is normal for fuel? Start with the fuel tap (called a petcock) in the horizontal position. This is pointing toward the back
...reserve fuel tank? if so where is the valve? have a 1977 and just bought upgrade and can't find anything in owners manual. My '96 does not have a fuel reserve. It does have a warning light that comes ...
Reserve fuel tank question... I tried to run my gas tank dry for Winter storage, expecting to get home on the reserve tank. When the main tank was dry, the reserve seemed empty too. Do I have to fill ...
...fuel reserve switch be pointed for on @ I had an older 600, and the fuel was in the on position when pointing straight up (12 o'clock). Reserve was in the 3 o'clock position, and off was the 9'oclock ...
...tank switch just need to know where the reserve tank switch is? It is a position (commonly marked R) of the fuel control valve on the bottom of the fuel tank where the fuel lines leaves the ...
Question about 2004 VT 1100 C Shadow Spirit
fuel shut off valve for reserve tank on a 2004 Honda VT 1100 C Shadow Spirit Hi, Anonymous 99% of fuel valve positions are as follows with the long end of the lever pointing: 1. Forward=off 2. Down=on
Usually answered in minutes!
188 Questions
186 Questions
195 Questions
148 Questions
151 Questions