Question about 1991 Cutlass Supreme
...fuel injectors. I took the intake off and unplugged the fuel injectors and want to make sure they are on right. INJECTOR #1-BLACK INJECTOR #2-BLACK WITH LIGHT GREEN STRIPE INJECTOR #3-BLACK W/PINK OR ...
fuel injectors went bad all at once. so what else could it be? possibly a blockage on carb fuel inlet the problem is the fuel injectors are not pulsing to deliver fuel, check to see if u have 12 volts
fuel injectors one of my fuel injectors is not working. i know that the fuel injector is good, so what else could it be There is a module to control the injector valve o and off. If it doesn't give a ...
fuel rail on... once you accessed and removed the fasteners, carefully pull up on the railon aboth sides.. a little wd may help release the injector seals, and you definitely wanna replace the lower o
...fuel from injectors will take over. But apparently fuel is not coming from injectors. And injectors is controlled by injector module. Injectors are normally closed until injector module tells them to ...
...fuel injectors.the injectors by being clogged and dirty.when you turn off car the injectors will leak causing plugs to foul out. go buy a bottle of fuel injector cleaner.go to gas station fill up gas ...
...runs rough with poor gas mileage. Code reads misfire in the 6th cylinder. My guess is that it's the fuel injector. But this only happens sometimes when the engine is cold. After being driven 10 to 15 ...
...fuel rails and you may have to pry up on the rails in places to get them to come out with the injectors attached the rails.you should make sure any debris is removed from around the injectors so no ...
...fuel injecters Assuming the injectors are already installed in the fuel rail, put a little fuel on the injector seals, position the injector rail in front of the holes in the head.Start from one end ...
Question about 1991 Cutlass Supreme
...fuel injectors to prevent damage to the electrical connector pins on the injector and the nozzle. The fuel injector is serviced as a complete assembly only and should not be immersed in any kind of ...
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
988 Questions