Questions & Answers for: Jeep fuel indicator flashing

Question about 1996 Grand Cherokee

1 Answer

sometimes will not start while driving i lose rpm,fuel,alt,temp gages factory alarm light comes on stays on no flash i drive home shut it down try to restart it starts then dies 7 to 8 times i play ...

Ad

Question about 2001 Grand Cherokee

1 Answer

...Hubby changed the plugs with no change in how its operating. The 'malfunction indicator light' is still on and blinking. Any clue as to what this may be?? Help! check the fuel pump and fuel ...

Ad

Question about 1993 Grand Cherokee

7 Answers

FUEL PUMP just cycle the key on, off, on ,off, then leave on. engine light will start flashing a couple of times after a few seconds. count them. will be once every second then a space then will start

indicator Light, Eg: (5) flashes, Then there will be a pause, then it may flash (3) times, this is a code #53. Keep your Eye on them and write them down. If you should miss (1) Repeat as many times as

Question about 1994 Grand Cherokee

1 Answer

...flashing that shows a problem?????? Change the following: oil, tranny fluid, and filters: air filter and fuel filter as well. Fill up tank and add 1 can of SeaFoam. Change spark plugs, wires, coil ...

Question about 1997 Grand Cherokee

1 Answer

...cherokee 4x4 Code 51 is ( Right Rear Fuel System Lean ) A lean air/fuel mixture has been indicated by an abnormally rich correction factor. Did you get this code by the flashing check engine

Question about 2002 Liberty

1 Answer

...flashing is not good. It indicates damage is being done to the engine and exhaust components, in particular the catalytic converter. You should have the vehicle checked as soon as possible. I believe ...

Question about 2002 Liberty

1 Answer

...fuel line Malfunctioning Throttle position sensor Defective MAP sensor Vacuum leak ...if your check engine light is flashing, then you are burning excessive amounts of gas which would indicate a rich ...

indicator circuit (manual transaxle). Code 41-Charging system circuit-output driver stage for generator field does not respond properly to the voltage regulator control signal. Code 42-Fuel pump or no

...BACKWARDS TO START OFF..WELL STARTED CRANKING IT AND FUSES GOOD RELAYS I SWAPPED AND NO POWER TO FUEL PUMP THE SERCURITY "KEY" LIGHT FLASHES LIKE IT'S A BAD KED ?? by placing the jumper batter on ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...