Questions & Answers for: Harley Davidson FXSTS Springer Softail fuel gauge wiring schematic

Question about 2000 FXSTS Springer Softail

1 Answer

...wiring schematic is part of the factory service manual. Harley-Davidson is very protective of their copyrighted material. You'll have to purchase a manual or find someone that has a manual to get the ...

Ad

Question about 2001 FXSTS Springer Softail

1 Answer

...fuel gauge. Start with a full tank and sometimes in drops to empty or half a tank????? Thanks Mark I have a wiring schematic of the fuel gauge on a '94 FXDWG. Your gauge may be physically a bit ...

Ad

Question about 2001 FXSTS Springer Softail

1 Answer

...wiring for the unit, the turn signals may not work. What you've done basically is taken the ground loop out of the turn signal module and coverted the lights to a frame ground. The ground is no ...

no spark 2004 softail, replaced crank sensor but still wont start, help Hi Josh, if you have a CKP sensor it needs compression to send correct signal to the ICM/ECM, make sure both spark plugs are in ...

I have a 2005 springer softail fxsts which runs lumpy when i throttle back slightly. is it a fuel problem Hi Virge554, and the usual suspects are: 1. Spark plugs in bad condition or partially fouled. ...

fuel Injection. Idles high at stops then returns to normal after 10 seconds How do I resolve Cold or operating temp my 2002 FXSTS takes approx 10 seconds to idle back down. code reads injector problem

Question about 2002 FXSTS Springer Softail

0 Answer

1999 harley softail have no low beams no low beams just high beam and small lights not working either Hi Johnny, check your hi/low beam switch for continuity and for a free wiring diagram please visit

Fuel tank vent system plugged or carburetor vent line closed off. 10. Carburetor controls misadjusted. 11. Damaged carburetor. 12. Loose or dirty ignition module connector at crankcase. 13. Faulty MAP

Question about 2001 FXSTS Springer Softail

0 Answer

Won't start,fuel comes out of left exhaust Hi Anonymous, when checking for spark the CKP needs to measure the compression bump in order to send the correct signal to the ICM/ECM so always check for ...

...wiring schematic for 01' Harley Hi, Brenda for this scenario you need a service/owners manual if you can not find the first and best tool you ever bought for your Harley despair not, for a mere $10 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...