Questions & Answers for: Jeep Wrangler fuel gauge wiring schematic

fuel gauge /tank need to know what color wires the fuel pump tie into?[black,tan,orange] I need to know the color of the wires leading to the fuel pump.

...and it sends the level of the fuel to the gauge, via wire transfer. there is a floater that is attached to the pump assembly, and it is damaged. replacing this sending unit will fix this

...fuel gauge wasn't working. I was told it was the fuel sending unit. I replaced the entire fuel tank and it still didn't work. I replaced the gauges and it still doesn't work. Can you tell me what ...

...fuel gauge and the batery gauge will not move when turn key on , engine will turn over but not start, checked all fuses and relays seem ok whot could be the problem? Jeep was running wife put it in ...

...fuel pump voltage, check other wires while cranking that will be fuel pump voltage and will only have voltage while cranking, or 3 to 5 secon after stop cranking. the one 5 volts will be gas

fuel gauge sensor Did away with all gauges and the chessy plastic printed circuit, put new mech gauges temp oil and voltage all working great ...the new fuel gauge is not working connected the s ...

...gauge and fuel gauge may be grounded out any body have any help for me searched for grounded wire found nothing may need a harness wiggle test-they jiggl the wiring around to notice a connection ...

Fuel gauge registers full when ignition is switched on Fuel gauge seems to be functional as it moves from empty to full when ignition is turned on. The gauge then always registers a full tank. Bad ...

to high If your fuel gauge always reads high, your fuel level sending unit sounds like it could be faulty. Could be bent or rusted etc. Sending unit wired up wring or faulty wiring system short/ground

fuel gauge dead and low fuel indicator lit. any ideas what makes you think it has one? 1st check all fuses in both boxes then make sure CEL glows, key on, NO CEL means NO EFI power. Check engine light