Questions & Answers for: Chevrolet 2500 fuel gauge

...Fuel gauge is also pegged over passed full. please help you may need to drop the fuel tank and see if the sendig unit or the fuel pump is the problem.once the plugs are off the tank everything should ...

1999 chev 2500,occasionally fuel pump cuts out,bought a new pump but have not installed yet,replaced relay did not help,noticed dash gauges not working when pump is cut out,dash gauges working pump ...

fuel gauge keeps going up and down! what does that mean???? The fuel sender in the tank needs to be replaced. I had a similar problem with my 2000. The needle would jump all over the place. I could be

...fuel gauge in dash 89 chev 2500 so I can tell if the gauge or tank unit is bad. The dash fuel gauge will change 1/4-1/2 tank overnight even if the truck has not been run. To test the gauge,unplug the ...

...fuel pressure gauge and measure on the fuel supply line on the rear of the inlet manifold. In my experience you need close to 4Bar while cranking. Priming pressure should be about 4.4Bar. This test ...

...so I'd have someone test the fuel pressure with a good, very accurate, gauge as that may tell the tale on what is happening. Good luck with your problem, hope this helps a bit! u may need a fuel ...

...fuel,fuel gauge also not working but that has not worked long before the problem started need help as it is dangerous to drive as it just cuts out at any time.No check engine light coming on? Is thee ...

fuel pump (in tank) and the problem went away. I hooked the pressure gauge up to the manifold connection and when I turned the key to the first position (activating the fuel pump) it read 62 psi. 

...fuel gauge stays on full no matter what level of gas Gas Gauge stays on full or smetimes shows empty except when gas is pumped in. It will show leve for awhile. It will then floating all ovver and ...

fuel gauge stopped working and truck died. Fuel pump was replaced 3 months ago Make sure battery has a full charge and battery connections all good. Have a helper crank it while you visually check for