Questions & Answers for: Nissan Sentra too much fuel

Slow to crank when hot I have the same problem, I used a fuel pressure testing kit to figure out why it does this. Here is what I found. 1) Fuel pressure drops when the vehicle is turned off, this ...

where is the fuel pressure sensor on a 2003 sentra 1.8 There isn't a fuel pressure sensor on a 2003 Sentra with a 1.8 engine, however there is a fuel pressure reguator, fuel filter and fuel pump which

how to change fuel pump on 2005 nissan sentra 1.8L 1. Release fuel pressure by removing the fuel pump fuse and spinning the engine over. 2. Disconnect the battery ground cable. 3. Open the fuel filler

how do i replace the fuel filter on a 2000 Nissan Sentra Fuel filter for SRDE20B15 engines (00-01) are in the tank mounted on top of the fuel pump inside the fuel assembly. Release fuel pressure by ...

how to change a fuel pump on a 2005 Nissan Nissan Car Altima & Sentra 1999-06 Repair Guide Fuel Pump - Removal & Installation Before servicing the vehicle, refer to the Precautions Section. ...

the fuel pressure when ignition is off is 0. and the car takes long to start sometimes With a fuel pressure gauge hooked up. the fuel pressure shoul d go up when you turn the key on. The fuel pump ...

2.o want stay running sems to lack fuel replace the fuel pump an filter getting fuel at fuel return linr but will not stay running if you give it starting fluid it runs fine till it runs out what to ...

...All the lights are working, just replaced the distributor cap and rotor and checked and I'm getting fuel through the fuel filter. Suggestions? A few Ideas from the 1995 Nissan Sentra maintenance ...

replaced fuel pump,fuel-injectors,fuel-regulator,fuel-rail,fuel-lines,ecm and all sensors that ecm will read. work was done at dealership. car still acts like its not getting enough fuel. I have to ...

How can I remove the fuel injectors? Disconnect the negative battery cable with a socket wrench and relieve the fuel system pressure. Disconnect the vacuum hose and remove the intake manifold ...