Questions & Answers for: GMC K1500 front sprocket

1990 GMC Sierra 4x4 1500 Front axle of 4x4 will not engage into 4 wheel drive when shifted into 4-wheel-electrical connections are live & working. iversonrc the connections near the front axle that ...

...of engine. http://autorepair.about.com/library/firing_orders/bl-fo-8624.htm If you were standing in front(knees to bumper) looking under your hood the #1 spark plug wire is at 5 o'clock and the next ...

Heater fan on 2002 Yukon does not operate in front, only rear. I have a problem with my 2002 gmc YUKON, Rear heater fan operates, but front heater fan does not blow, do both fans operate on same ...

Front drive shaft not fully engaged in 4WD, with truck on stands all 4 wheels do rotate but if i stop front wheels the front drive shaft is not engaged Hi, Do you have auto locking hubs on the front ...

.... Need to know what the factory speaker sizes for my 1990 gmc k1500 the correct speaker size is 4x6 front and rear the fronts are simple be careful with the back as panel clips break ...

to do a front end alignment on a 1991 GMC Sierra K1500 4x4 requires some shims being knocked out, right? It's not just a standard front end alignment, right? yes you do have to knock shims out if you ...

sprocket. NOTE: The composite type engine front cover and seal must not be reused. Always install a new engine cover with a new seal. Install new engine front cover and bolts. Torque bolts to: 106 in.

where is the properplaceto put the jack On the frame, if its a front tire or front of truck place jack on the front part of the frame, heres a few diagrams to help you locate the correct area to jack.

4 WD will not engage on my 1993 GMC 1500 Sierra By any chance have you jacked up the front of the truck and set it on jack stands. And engage your 4x4 and see if your wheels turn at all. You might ...

...are locked in and i shift it into 4 high it will not work it grinds and back tires spin but not the front, this also occurs sometimes in 4 low. front hub may not be pushing gear into hub remove hub ...