Questions & Answers for: KTM front sprocket

front sprocket - after sand race, i removed sprocket to clean area - seal spacer looked worn? from sand - does someone make a better part? im not sure but i race hare scrambles to i usually just put a

...front sprocket is this a hard fix Yes and No, But it does depend on your knowledge. It will mearly be a seal that needs to be replaced. You will need to drain your gearbox oil and remove the cover, ...

...Spokes 5Nm 4ft lbs Other Screws on chassis M6 10Nm 7ft lbs M8 25Nm 19ft lbs M10 45Nm 33ft lbs Other collar nuts on chassis M6 15Nm 11ft lbs M8 30Nm 22ft lbs M10 50Nm 37ft lbs Front Sprocket 44ft ...

...front sprocket remove the sprocket, hook out the seal and replace, make sure all is clean, and no grass or wire has caused it. You can usually remove the spacer that is over the shaft that the ...

...front sprocket. Already took of rear sprocket and chain. Rear gone in trash, thought putting it in gear would hold sprocket, but it won't. what is the best way to remove it know? Wait until you get ...

what is the torque settings for the front sprocket There should be a spline for the sprocket and do the nut up hand tight plus an 1/8th turn with loctite blue threadlock.

...Front axle pinch bolts 10Nm 7ft lbsCollar nut, rear wheel spindle Rear axle nut 80Nm 59ft lbsHex nut swingarm bolt Swingarm nut 100Nm 74ft lbsHex collar screw handlebar clamp Upper handlebar clamps ...

...19ft lbs M10 45Nm 33ft lbs Other collar nutes on chassis M6 15Nm 11ft lbs M8 30Nm 22ft lbs M10 50Nm 37ft lbs Front Sprocket 44ft lbs Let us know if we can provide further assistance. Best regards, ...

front sprocket? Thank you for contacting FixYa with your inquiry. Go to this link and drill down to below indicated: http://cyclehuttktm.com/FicheFinderNew/FicheFinder.aspx 2001 > 400 SX RACING >

...front sprocket off Take off front sprocket casing and gear lever,..leave on chain until you have loosened the sprocket retaining nut, there may be a tab washer on the shaft,..if so,use a screwdriver ...