Questions & Answers for: front axle assembly

...front left axle seal bad. I took the left side apart and not sure how to get the seal back in. Do I need to open the inspection cover on the diff. and take the gears out? Rear Axle Notes Raise and ...

...Front axle case assembly and front drive shaft assembly (LH side). Lower the vehicle and disconnect the RH front drive shaft assembly, and then remove the front axle case assembly and front drive ...

...front left axle? to remove your front axles also known as cv axles you have to pull your brake caliper and rotor off. Then you have to break your hub assembly nut that holds the cv axle tight to the ...

...Front Right; w/o ABS $42,99 THESE ARE LEFT SIDE AXLE AND CV JOINT ASSEMBLY. A-1 CARDONE Part # 604155 {[CV Half-Shaft Assembly] Reman.} Front Left; w/M.T. w/ABS $53.79 A-1 CARDONE Part # 604150 {[CV ...

...front wheel bearing/hubs can be a big job for the inexperianced. Briefly... Remove tire/wheel Remove brake caliper assembly, do not remove brake line. Remove caliper bracket. Remove brake rotor. ...

...axle nut has been properly torqued or damage to the front wheel bearings will result. With the vehicle's brakes applied, torque the axle nut to 180 ft. lbs. (244 Nm). Install the spring washer, nut ...

front axle assembly used on most 4wd models covered by this manual utilizes a central disconnect type front axle/transfer case system which allows shifting in and out of 4wd when the vehicle is moving

Front axle nut torque spec 2004 chevy silverado 2500HD? Torque specs front axles nut Here are the front axle nut torque specs for the 2004 Chevy Silverado 2500HD: • Axle Shaft nut - 177 ft-lb • hub ...

...Front Axle consist of the following components: • Differential Carrier Housing • Differential Case Assembly • Inner Axle Shaft • Intermediate Shaft Bearing Assembly (located on the right side of the ...

front & rear axle assembly for a 1999 HD FXD Dyna Super Glide What instructions do you need. You remove the rear ring and nut and pull or gently drive the axle out and for the front you remove the nut