Questions & Answers for: Carrier freon amount

Question about 38CKC042 Air Conditioner

5 Answers

...AMOUNT OF FREON TO PASS. I had similar problem once. A spider got fried onto the on/off contact switch and kept the unit from turning off. Solution: Cleaned switch. this is caused by air restrition ...

Ad

Question about 38CKC042 Air Conditioner

1 Answer

...amount just be replaced / charged????? Carrier 38TDB037---30 / Indoor Coil FE4AN yup, entire system needs to be drained, and leak needs to be repaired first before charging with freon. after sealing ...

Ad

Question about 38CKC030 Air Conditioner

5 Answers

...house is completely encased in ice. Does this mean the unit is bad ? Or, does this mean there is a freon leak in the tubing ? And, is it cheaper to replace to unit or try to find the leak at $150 / ...

Question about 38CKC042 Air Conditioner

1 Answer

...Amount Of Freon? Help!!!!!! It Is Too Hot Here......:) Yes it could be low on refrigerant. The other cause of ice-ups is poor air flow caused by a dirty filter or intermittent blower failure. If it's ...

Question about XHB123D X/Y Series Heat/Cool Air Conditioner

4 Answers

...amount of freon.This would give a tech.a false reading if he where to attach ac gauges up to read pressures.It has happened before.The ac units are charged with a machine,and between freon and the ...

Question about 38BRC036 Air Conditioner

1 Answer

...freon was lost. Going to do a recover tomorrow and weigh what I recover. I guess then reload correct amount. But really want to get compressor to run all the time. Hello RR Hard start can't hurt BUT ...

Question about 38BRC036 Air Conditioner

1 Answer

amount of GAS FREON 3.5lbs I found out that the radiator is freezing on very the lower portion only not complete I also cleaned the fan area the only problem is that it is not cooling much and faster.

freon was put in in the compressor and the refrigerant line started to freeze. model# 38tkb048350 have a ac specialist check the charge pressure in the system I suspect that the refrigerant gas amount

amount of freon off the data plate on the condenser unit or you'll have to use a clamp on current meter to read the FLA specification on the data plate to get the correct amount of freon into the unit

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Carrier Heating and Cooling Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Are you a Carrier Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...