Need to replace freeze plug on engine Need to replace freeze plug on 4.3 liter engine. Can I replace the plug by pulling the right tire off or do I need to jack truckup to get to freeze plug. both... ...
How to replace rear freeze plug 1993 Chevy V6 S10 4.3 liter You will have to pull the trans to get to the freeze plug. Take a punch and knock one side of the plug in then pull the rest of the plug out
i need to find the freeze plugs on a 2000 chevy s10 4.3 litre There are freeze plugs in the heads at both ends, also on the sides of the engine block below or behind the exhaust manifolds.
Where are the freeze plugs located on a 1997 chevy s-10 truck? A freeze or expansion plug is a small, metal, circular plug that lives in various places on an engine block. These plugs have a valuable ...
water leak s-10 v-6 engine block above moter mount Sounds like freeze plug or head gasket. check your freeze plug
the freeze plug came out and water drained.Now when I fill truck back up with water .It runs out of spark plugs holes. what exactly caused the freeze plug to come out if it froze hard enough to push ...
...replaced the water pump cause it had been leakin. right before i cranked it. i put 1 gallon of antifreeze and half of water. then i started it and it started leaking anti freeze and it was burning ...
What happens when you drive without antifreeze? Hello registerdal: My name is Roger and I will answer your question. If you have no coolant in the radiator the engine Will overheat and cause severe ...
where are the 1997 chevrolet s-10 blazers freeze plugs located? Hello: Freeze plugs at the end of each head. The main freeze plugs are in the block on the side. To access them you may have remove the ...
Leaking freeze plug It is leaking anti- freeze from what looks like the back passenger side motor mount, then runs down pipe to look like it is coming from under the floor . Will I have to pull the ...
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions