Questions & Answers for: Indesit frame grips

indesit 123. Will not drain. Goes into spin cycle when set but no water comes out. Checked hose at front and rear. Set cycle to delicates. Knob went round and round continuously and still lots of ...

New glass door into frame How do I slide the new glass window in between the frames? I cannot see how to keep the glass in? usually only avaliabel as compleate door.

...How do I do this? Thanks in advance Undo any screw that you can see on the inside of the door frame, and then prize the two halves apart, This should give you access to the door handle assy. ...

diplomat apm8703 heater element gone i have located the heater, undone the nut which i assume holds it in place but cannot seem to remove it, i dont want to apply too much pressure for fear of ...

...at the bottom is not there then thats why the door wont catch,there are some screws around the door frame if you take them out and just pry apart the door frame by the catch you will see the pin at ...

...it pushes the latch part in towards the outside edge of the door. the pin goes through the door frame, then through the spring's 'holes', through the latch, and back into the frame of the door. ...

filter can't get it out I guess I should be able to remove the filter to clean it. I can turn the filter but it will not come out do I pull very very hard or will that break it? If you have turned the

water sensor light keeps coming on even tho tank empty have checked hoses and cleaned large filter at front try cleaning out the condenser unit, instuctions are on pages 2 and 3 of your manual, if you

How/where can i get a door frame (without glass) for indesit w1235 washing machine? thanks Assuming you're looking just for the outer door frame, this should do the trick: ...

front panel seal how do i get the wire to stay inside the seal the one that go's at the back Theres probably a clip of some kind that holds it from the inside frame