Questions & Answers for: fork bearings

...bearings, at top of fork tube, do not lose bearings which may be loose. withdraw fork from fork tube, do not lose upper bearing race remove lower bearing from old fork install lower bearing on new ...

fork head and adjust the bearings to just remove slop. Recheck the rotation. When putting the forks and wheel back, check the shock action of each fork individually. If the machine has a lot of miles,

...bearings, swing arm bearing preload, worn defective shock, bent frame, rims. forks. misaligned forks. fork stiction. Prevention is in making all above are correct., a steering damper won't fix it, it ...

...bearings nuts are not loose nor are my fork tube clamps. but i still feel like the fron wheel is tracking side to side. do you know what i mean? oh ya checked front axle its tight too. are the forks ...

...The steering stem bearings and mounts should be okay as is. Before you buy, be sure the new forks are the same diameter as the old forks. Also check the overall length of the forks. The

fork is sticking up through the hole in the top triple prior to removal. if you do want to remove the triple trees and replace your neck bearings, you will have to cut the bottom bearing off, i've

install clutch fork easy way to change clutch fork No easy way-no shortcuts. The transaxle has to be removed. The fork is attached to the clutch release bearing which is on the transmission's input ...

...stay, The gearbox is still a cast iron type, and has a hydraulic sustem with a lollypop type fork, there is a constant pressure on the thrust bearing because of the hydraulic sustem , is the ...

...bearings cannot be reused, they must be replaced. 1. Support motorcycle so front end is off floor and forks are fully extended. 2. Remove right side cover and remove maxi-fuse. 3. Remove headlamp and ...

...fork seals and steering head bearings only then to find that the forks in my GS are not GS forks. After some investigating I have found that the forks in my GS are actually GSX Katana forks. I am ...