...spout on 88 ford crown 302 fuel inj I need to base line time the 302 and I can't find the spout to disconnect the computer on this 88 ford crown vic. Sisters car had loose dist. lock bolt the spout ...
...ford Ranger xlt ,2.8 dual 4 Cycinder extended cab The "Inline Spout Connector" is used to control the engine timing by dis-connecting the timing control from the timing control unit, and you must ...
...ford mustang gt 5.0 HO 5 speed 10 DEGREES BEFORE TDC WITH SPOUT CONNECTOR DISCONNECTED , I THINK THAT ON THAT MODEL THE CONNECTOR WAS LOCATED IN THE WIRING HARNESS AT THE DISTRIBUTUR CONNECTOR HAS ...
spout connector located on Ford Ranger 1987 2.3L 4 cylinder. and what does it look like. Hello pennockgaryc: My name is Roger and I will help you. The spout connector will be taped to the wire harness
1988 mustang 2.3 liter,no turbo,natural.Where is the spout connector located The spout is located in the wiring haness next to the Ignition module, it is a square plastic shorting plug.
...pictures that may help, also other wriitten directions that tell of other possible locations to find ...
spout connector for 1989 ford f250 xlt lariat if you look on the distributor you will see the large connector for the mudule bolted to the side. The spout connector will be within inches of the module
...plug should be in the harness at the distributor. look for the shorting bar spout connector located left rear corner of the engine compartment where it goes into the TFI ICM MODULE HARNESS
...ford explorer ? The spout is located in the front left (drivers) side of the engine compartment. Below is a picture of it's location (marked with a red arrow). Also below is a picture of the spout ...
89 chevy blazer spout connector located where is the spout connector located on my 89 blazer? and also the egr system? Only Ford products used a spout connector during the 1980s and 1990s.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
