Questions & Answers for: Bronco II ford carburetor

1990 full size bronco, won't start the engine will turn over but will not fully crank. I think it maybe the carburetor. but how would I know for sure. or could it be anything else. check to see if you

poor idle tune up Low / uneven idle problem can cause by a lot of components. Dirty air filter Dirty injectors + o-rings Vacuum leak at intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC

I have a 1986 Bronco II with 4 wheel drive and automatic trans. 185,000 miles when it warms up it will stutter and lose power when you try to accelerate. I am able to baby it up slowly to a faster ...

having trouble start have to hold the accelerator pedal to the floor? If it is carbureted,then the carburetor needs rebuilding most likely,and replace the float in the caburetor also.

...carburetor. Hand-start the tube nut into the fuel filter. While holding the filter with a wrench to prevent it from turning, tighten the fuel line tube nut. Start the engine and check for fuel leaks. ...

...Ford Bronco II. One reason is that early model used an open fuel system and none injectors. With the alcohol additive will low the boiling point of the fuel causing it to boil away; therefore, ...

...ford bronco running rough? my truck will never turn on with first crank, i have to crank and crank and hold the gas for it to start and it has to heat up for about 10 minutes and when its ready to go ...

how can i change my 87 bronco II 2.9 L from fuel injected to carbureted ? I have tried everything I can think of to get this vehicle to run right. I hace changed everything including the ECU. So, I ...