...2 gray, etc) compared to my ford. Any suggestions? since it worked before and you didnt change anything and now there is no power it looks like you blew a fuse when connecting wires. check the radio ...
...Ford tempo had the engine replaced quite some time ago. When the new engine was installed, the a/c was not hooked up. When this was brought to the mechanic's attention, he took a wire and hot-wired ...
...YEL/BLK. Key on in neutral you should get voltage at WHT/BLK, and YEL/BLK. Key on in 2 you should have voltage at RED/BLK, and LT BLU/BLK. Key on in 1 you should have voltage at RED/BLK, and
Question about 1994 Explorer Limited
...ford explorer Check out autozone.com. Once you register you can look up all kinds of information for your vehicle. How to information, wiring diagrams, exploded views, firing orders, diagnostic code ...
...lt. blue -- tps signal return gray/red ----- signal return red/white ---- reference voltage with a 6.0 diesel tan--------ref. volts yel/white- apps 1 signal blk/org---- signal ret. white/red- apps 3 ...
Question about 2006 F-250 Super Duty
...ford ranger 4x4, 3.0 liter v-6 Flex Fuel vin letter V, back in February .... I drove it less than 200 miles and the engine blew ....... Here it is now, December, and I just had the engine replaced ...
Ford Explorer, Eddie Bauer Edition with steering wheel controls. There are 2 wiring harnesses going to the back of my radio. The big one for the radio but the small square one has 4 wires and I'm lost
...Ford Escape 3.0 Xlt. I’ve already fried 2 sensors in the process! I’m so aggravated Here you go. White/red heater Lt green/black heater orange/black signal grey/green ground. You may be able to find ...
...2.3 harness 1993 ford ranger. no car told at all 2.5Liter sourced from wow, that is a hard nut to crack leaving all that out. my guess 1998 2.5L the old PCM will not like what you just did. for sure ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions