...marks on flywheel where?? well the bike is a gilera runner 125vx. im timing the bike up but cant find the timing marks on the flywheel...little help?? think most bikes time from the statas plate ...
flywheel marks. There is no #1 cylinder, this ain't an automotive engine. You have a front cylinder and a rear cylinder. All timing marks on the flywheel are for the front cylinder. Front cylinder
...marks. If your timing is off, its usually due to a sheared flywheel key, you can check this by removing the nut on the flywheel and seeing if you can tell the key slot on the flywheel lines up with ...
Question about 2005 Runner VXR 200
...marks are on the stator (behind the flywheel) and the cranckcase. The timing can't ever be that far out as there is a limited amount of movement of the stator, it is fitted with three screws in ...
Question about 2005 Runner VXR 200
...timing mark on flywheel did this mark represent tdc? start a fresh ! plug out and turn piston to tdc and mark flywheel ! have you moved the timing plate ? soz i dont know the degree time this is just ...
Question about 2005 Runner VXR 200
same spot. Is it a new flywheel? Was it balanced? There are no timing marks on the flywheel. Does the gear on the starter line up with the flywheel teeth? Does the engine turn over? Would like to help
flywheel up with its ignition cycle obviously but yes the cam has marks for the crank No, there is a key in the shaft that ensures that the flywheel is lined up properly. These sometimes shear and the
Question about 2005 Runner VXR 200
...marks on the injector pump with the 22 degree mark on the flywheel if the pump is gear driven you will have corresponding timing marks on the idle gear and the crank gear the degrees on the flywheel ...
Question about 2005 Runner VXR 200
...marks on flywheel because of aftermarket flywheel. possible ways of setting the 3 degrees and finding exact timing. 2004 hino j08c direct injection zexel pump aftermakret flywheel no marks The best ...
Question about 2005 Runner VXR 200
...marks then remove flywheel being careful not to move crank.Then observe ohm meter and position points to where contacts just open. Double check by putting flywheel back in place and turning crank and ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions