...rotor gap for a Poulan Pro 285 Remove the plug. Place a business or index card between the coil and flywheel. Rotate the flywheel until the magnet holds the coil tightly against the card, tighten all ...
Question about Pro 22" Self Propelled High Wheel Mower
...the mower won't start, Blade is turning when I crank it but it doesn't even attempt to start The flywheel key has sheared or partially sheared which throws off the spark timing. Removing the ...
no spark Assuming that you have tried a new plug with no results, remove the flywheel side cover to expose the flywheel and ignition module. Remove the ignition switch wire from the module and try for
...setting for a Poulan Pro 220 16''? I assume you are speaking of the ignition module pole gap to the flywheel. Rotate the flywheel magnets under the ignition module poles, and use a thin business card ...
5200 no spark Remove the left side cover to expose the flywheel and ignition module. Set the module pole gap by turning the flywheel magnets under the module, insert a thin business card into the pole
Question about P3314 14" Gas Chain Saw 2.0 Cuin 33CC 2 Cycl
...no more details Dorothyjack: It sounds as though your magneto has gone out of timing. Between the flywheel and the drive shaft there is a small square key that keeps the flywheel from slipping on ...
Question about P3314 14" Gas Chain Saw 2.0 Cuin 33CC 2 Cycl
my micro 25D has no spark. what should i check next? where the flywheel is there is a pick up coil bolted close to the outside of it and there should be close tolerance between it and the flywheel. ...
...how You need to pull the blower housing off. Then remove the the starter cup from on top of the flywheel. Pry off the flywheel usually by insert a prybar under the flywheel pulling up while tap
removing flywheel nothing yet You use a flywheel knocker tool to loosen the flywheel. It is threaded on the crankshaft until seats and back off one turn. Then you lightly tap it with a hammer to jar ...
Question about P3314 14" Gas Chain Saw 2.0 Cuin 33CC 2 Cycl
...i have good spark .when i go to start it jerk the cord out of my hand.i set the gap between the flywheel and mag 6thousands Typically it's the flywheel. The key is molded into the flywheel which ...
Usually answered in minutes!
583 Questions
457 Questions
255 Questions