...tube. Some screw directly into a brass emulsion tube which is machined for a 7mm wrench at its float chamber exposed base. Inlet Fuel Valve: Inspect the needle valve & spring. Press down the ...
...the present problem what has most likely happened is there has been fuel sediment left in the float bowl (if it's a carburetor engine) this unfortunately will need to be removed cleaned and put ...
...setting the float level be aware that the spring loaded bumper on the fuel inlet needle valve may have a tendency to compress under the weight of the float assembly which will skew your measurement. ...
float when you cleaned it. Then more than likly the setting didn't change. Check the seat on the plunger (rubber that meets with metal). The one that is connected with the float (it sometime has a
...the resistance of the air filter in order to get the proper vacuum to "SUCK" the fuel out of the float bowl and create the proper venturi effect. Improper mounting and sealing of the airbox will ...
...the resistance of the air filter in order to get the proper vacuum to "SUCK" the fuel out of the float bowl and create the proper venturi effect. Improper mounting and sealing of the airbox will ...
Usually answered in minutes!
51 Questions
53 Questions
41 Questions
44 Questions
27 Questions