Questions & Answers for: Honda GL 1500 Gold Wing float setting

...360 [email protected] well i will tell you that im a motorcycle tech and it sure sounds like the float level is too ...

...noisy when i pull away The caliper should be bolted on tightly at the mounting points, but should float back and forth so the pads do not wear unevenly. Other things to check for odd front end ...

cruise set will not set Those are pesky little microswitches. Also the brass bushes wear in the lever and need to be replace every now and again (available from honda). Update on the cruise setting ...

my Goldwing has been sitting for about a year , I had to replace the fuel pump and i have it running but now i have a fuel leak on the left side coming from a valve , i thing the floats are stuck in ...

...float setting for 1988 GL1500? Per Clymer, it should be set to 0.31 which is higher than the setting when disassembled. Does float setting take into consideration the ridge on float or should setting ...

what is the correct float level for an 89 GL1500 Gold Wing Thanks! from the mating surface of the bowl to the bottom of the float at rest aganist the needle spring 13.7 mm

...goldwing, i have fuel leak on right side of the bike, also the gas goes inside the engen One of its float bowls on one of your carbs is overfilling due to the needle valve which should shut off when ...

...this. I'm going to start a tare down this weekend. Just looking for advice. I would have say the float in your carb is stuck. Take the bowl off the bottom and see if your float needle is sticking ...

...Anonymous and the usual suspects are: 1. Damaged or restricted fuel tank venting system. 2. Loose float bowl screws. 3. Damaged float bowl o-ring. 4. improper fuel level in the float bowl. 5. Worn ...

I started the engine, but then after a minute it started to lose power and stopped. I opened the choke fully, started it again but it failed shortly after, and would not start again Feels like the ...