Questions & Answers for: Toro float setting

float is set at the right setting. Little pieces or rust in the bowl will be sucked up into a jet and plug it up and stop it from running. Do not leave gas in your mower over extended periods of time,

by removing the bottom bowl nut. Use a small can or an ash tray to hold the small pieces. Shake the float back and forth to see if there is anything in it. Some floats are plastic and some are tin. If

...everything out, bottom the jet and back out the number of turns out, noted for that jet. Open the float chamber, and clean as necessary, Inspect the float adjustment: invert the carb, and observe ...

...the carburetor on a Tecumseh LEV100 motor and the little "spring" that is part of the float assembly fell out. I'm not sure exactly how to put it back in and I feel like this might ...

...that you use a laquer thinner type cleaner to clean and dissolve the laquer build-up in the float and needle jet passages. Be sure to remove all plastic and rubber parts before using the ...

when trying to start fuel spits out of the carburator Remove carb float bowl. Clean bowl. Get model no. of engine and get new float bowl gasket set at mower repair store. Ensure float drops down ...

...that you use a laquer thinner type cleaner to clean and dissolve the laquer build-up in the float and needle jet passages.Be sure to remove all plastic and rubber parts before using the

...when tilted alittle back. It has a new carb and also did so with old carb.Any ideas why?? CHECK THE FLOAT IN THE CARB YOU MAY HAVE TO SET THE FLOAT . THE FLOAT MAYBE SET TO LOW CAUSE THE TO FLOOD ...

...ethanol gas ruins the seat if they are made of rubber and the needle valve is all metal. Does the Float actually move up and down as it's supposed to? sometimes the ethanol gas absorbs too much ...

what is the toro ccr1000 float setting level with the carb body. don't forget the spring for the float either.